tag:blogger.com,1999:blog-3615478772815290200.post7308485782384897656..comments2024-02-21T19:57:00.859+01:00Comments on 3D printer improvements: How to clean the hotend and nozzle from the outsideJeremie Francoishttp://www.blogger.com/profile/02984201174566394892noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-3615478772815290200.post-91512516904989590002013-03-11T12:05:02.245+01:002013-03-11T12:05:02.245+01:00I think 30W gauge wire is ok, and you probably fin...I think 30W gauge wire is ok, and you probably find very small quantities on ebay for a few bucks b/c they are used to hack game consoles<br />You may double check the diameters here http://en.wikipedia.org/wiki/American_wire_gauge<br /><br />- CheersJeremie Francoishttps://www.blogger.com/profile/02984201174566394892noreply@blogger.comtag:blogger.com,1999:blog-3615478772815290200.post-27231625200507048802013-03-09T14:19:59.320+01:002013-03-09T14:19:59.320+01:00Thanks I need to try this as I couldn't take a...Thanks I need to try this as I couldn't take apart the nozzle before. The hard part is to find a thin enough wire. UncleBobhttps://www.blogger.com/profile/01591617773519765384noreply@blogger.com